.jpg)
The six matters for incresing the service life of the efficient fine crusher
2015-01-04
For the normal running of China Juxin efficient fine crusher, it's very necessary to pay attention to its daily maintenance, especially the lubrication for the bearing. In the working process, the efficient fine crusher can produce a large mount of heat, so its tempreture will rise. At the same time, its long-term running will damage the bearing. So the lubrication for the bearing will derectly influent the running of the whole production plant.
For the better running of the bearing, China Juxin Machinery introduce the technique of oil and lubrication for pebbles stone fine crusher's bearing.
1.Antirust performance: the grease which is used for the bearing must have antirust effect, and the rust inhibitor is better not dissolve in water. Grease should have good adhesion and can form a oil film layer on the surface of steel. China Juxin fine crusher adopt the grease with high antirust performance.
2.Mechanical stability performance: sebum in machining will become soft, cause leakage.During normal operation, oil will by the bearing to the bearings. If the mechanical stability of the oil is insufficient, operation process, the structure of the soap grease causes mechanical disruption of oil was damage and loss of lubrication.
3.Oil seal: oil seal is necessary to protect bearings and lubricants from the barrier of contamination from, bearing in the process of operation, regardless of debris or moisture can penetrate bearings, in case of causing damage to it.Have a bearing on the correct installation and maintenance is an important factor of the longest service life. At the same time, must pay attention to the correctness of the purity of the bearing, bearing selection and choose the proper installation and maintenance tools. In addition, the bearing must prevent polluted by contaminants and moisture, and ensure that the right be installed and lubrication.
4.Mixed oil: never mix two greases which are incompatible, if so, they usually will soften itself consistency, and at the smae time, its loss might damage the bearings. If you don't know what kind of grease you've used for your bearing, you must first remove the old grease from inside and outside bearing, then add new grease.
5.The classification of grease: according to the temperature and the working conditions: low, medium and high temperature with grease. At the same time, there is a certain type of grease known as resistance to squeeze or extrusion and add molybdenum disulfide, at the same time, among them with additives to enhance the strength of the lubricating oil film.
6.The important factors for choosing grease: choose a grease, its oil viscosity in working temperature is it is important to be able to provide adequate lubrication effect, viscosity is mainly affected by temperature, it with the temperature rising and falling, is that it increased when the temperature decreases.Therefore, you must know when working temperature of the oil viscosity.
Choose the better grease for your fine crusher, choose China Juxin pebbles stone fine crusher!
